What Paver Sealing Costs in Florida
Paver sealing cost in Florida typically runs $0.50 to $2.00 per square foot for a professional job, with most residential projects landing between $200 and $800. South Florida sun, rain, and salt air break down unsealed pavers fast — fading the color, washing out joint sand, and letting weeds and ants take hold. Sealing locks all of that down for two to three years at a fraction of what a paver replacement would cost.
This guide breaks down what you can expect to pay in West Palm Beach and across the Treasure Coast in 2026, what changes the price, and how the math works for the most common project sizes.
Per-Square-Foot Pricing
Most professional paver sealers in South Florida price by square foot, with a minimum charge that covers travel, equipment, and basic prep:
- Standard sealing (re-seal of clean pavers): $0.50 to $1.00 per square foot
- Full prep + sealing (cleaning, re-sand, seal): $1.00 to $1.50 per square foot
- Restoration sealing (faded, weathered pavers): $1.50 to $2.00 per square foot
- Minimum charge: $200 to $400 for small jobs
The prep tier usually applies — most homeowners want pressure washing and joint re-sanding included so the sealer goes on a clean, stable surface.
Project Totals by Type
The square-foot rate is one number; the actual project cost depends on how big the surface is. Here is what typical Palm Beach County and Treasure Coast jobs look like:
- Paver walkway (100 sq ft): $200 to $400
- Paver patio (200 sq ft): $300 to $600
- Pool deck (300 to 400 sq ft): $400 to $1,000
- Driveway (400 to 600 sq ft): $500 to $1,500
- Large estate driveway and pool deck combo (1,000+ sq ft): $1,500 to $3,500
Pool decks and driveways are the most common projects we seal at Domi Landscape because they take the most weather and traffic. A two-car driveway with a connected pool deck is a single trip and often the most cost-effective way to seal everything at once.
What Changes the Price
Several factors push paver sealing cost up or down inside the per-square-foot ranges above:
- Surface condition — Faded, mildewed, or oil-stained pavers need extra cleaning passes, sometimes a chemical wash, and occasionally a stain treatment before sealing. Add 10 to 25 percent.
- Joint sand replacement — If your joints have washed out, polymeric sand replacement runs $0.10 to $0.30 per square foot on top of sealing. This is almost always worth doing — sealing without re-sanding leaves gaps that defeat the point.
- Sealer type — Water-based acrylic is the budget choice; solvent-based and urethane sealers cost more but last longer. Wet-look or color-enhancing finishes also cost more than natural-finish sealers.
- Access and obstacles — Pool deck pavers around tight pool coping, fenced backyards with no equipment access, or properties with extensive landscaping bordering the pavers all add labor time.
- Coverage rate — Older or porous pavers absorb sealer faster, so a job that "should" need 5 gallons may need 7. Pros typically estimate conservatively to avoid running short.
- First-time vs re-seal — A first sealing on never-treated pavers costs more than a re-seal because the prep is more involved.
For a project like a paver patio installation that was finished within the last year, sealing is usually toward the low end of the range. For a 10-year-old driveway that has never been sealed, expect the high end.
DIY vs Professional Sealing
DIY paver sealing supplies cost $50 to $200 for materials (sealer, applicator, polymeric sand, pressure-washer rental). The labor is the catch — even a 200-square-foot patio takes most homeowners a full weekend, and getting the prep right is the part that determines how long the job lasts.
Common DIY mistakes that cut sealer life from three years to one:
- Applying sealer over damp pavers (traps moisture, causes a white haze)
- Skipping the polymeric sand step (joints wash out within months)
- Applying too much sealer (creates a glossy, slippery surface that peels)
- Using the wrong sealer for the climate (some products fail in Florida's UV)
A professional job on the same patio runs $300 to $600 — usually less than two times the DIY material cost — and typically lasts two to three years with proper prep. Most homeowners who try the DIY route once hire it out the next time. If you do go DIY, plan to seal again every 18 to 24 months instead of 30 to 36.
How Often Should You Re-Seal
In South Florida, expect to re-seal pavers every two to three years. Heavy traffic surfaces (driveways, primary walkways) trend toward the two-year mark; lower-traffic patios and pool decks can stretch closer to three.
You will know it is time to re-seal when:
- Color has faded or looks chalky
- Water no longer beads on the surface
- Joint sand has washed out or weeds are appearing
- Pavers look perpetually dirty even after pressure washing
Routine re-sealing is much cheaper than letting pavers go too long. Pavers that have not been sealed in five years or more often need restoration work — re-leveling sunken sections, replacing lost joint sand, and sometimes replacing damaged pavers — before they can be sealed at all.
Why Pavers Beat Concrete in This Climate
If you are still deciding between paver and concrete surfaces, the paver vs concrete comparison is worth reading before the install. Sealing cost is one factor where pavers actually edge out concrete: a sealed paver surface holds up significantly better against Florida's UV, rain, and pool chemicals than a poured concrete deck of the same age. Pavers also let you replace single units if one cracks — try that with a concrete slab.
Getting a Paver Sealing Quote
A site visit produces a far more accurate quote than a phone estimate. The pro should walk the surface, measure square footage, check joint condition, identify any restoration needs, and ask about your timing and finish preferences before quoting.
Domi Landscape provides free, in-person paver sealing quotes across Palm Beach County and the Treasure Coast — including West Palm Beach, Stuart, Port St. Lucie, and Fort Pierce. We will tell you whether your pavers are ready for a straight re-seal or need restoration first, what the project total looks like, and what finish (natural, color-enhanced, or wet-look gloss) will hold up best on your specific surface.
Ready to Get Your Pavers Sealed?
Call (772) 349-5118 for a free quote on paver sealing across the Treasure Coast. We service residential driveways, pool decks, patios, walkways, and commercial paver surfaces — and we will give you a straight answer on whether sealing is the right move for your project.